
406342
‘’ The appliances are suitable for photovoltaic electrical power
under the condition that electrical voltage will be 220VAC -
240VAC with semi tonic frequency 50Ηz in order the appliance
to operate properly (alternative a generator can be used with
the same technical characteristic).’’
• Incorrect connection may destroy parts of the appliance,
making the warranty void.
• Before connecting the appliance, make sure the voltage
indicated on the rating plate is consistent with the voltage
in your home network. Connection voltage (230 V through
N) should be checked by a qualifi ed technician using a
corresponding measuring device!
• Connection cable on the back of the appliance should be led in
such way that it does not touch the appliance back wall, as this
part will get very hot during operation.
NOTE:
Connection bridges are already installed on their respective
places on the clip. Screws of the connection terminals are open,
which means they do not have to be unfastened or unscrewed
any further. When fastening the screws, you may hear a slight
‘click’, which means that the screws should be fastened /
screwed in completely.
The following can be used for connection:
• Type H05 RR-F 4×1.5 rubber connection cables with a green-
yellow protective wire,
• Type H05 VV-F 4x1,5 PCV insulated connection cables with
yellow-green protective wire, or other equivalent or superior
grade cables.
Connection diagram
ATTENTION!
• Before any manipulation with the appliance (other than its regular use), disconnect it from the
power mains. The appliance should be connected according to the relevant scheme (diagram),
subject to the network voltage. Connect the earth (PE) wire to the clip indicated with the earth
/ground symbol.
• The mains cord must be fed through the fastening clip / strain release device which protects it
from being pulled out accidentally.
• After connecting the appliance, turn on all cookers for approximately three minutes to check their
operation.
19
Kommentare zu diesen Handbüchern